How To Properly Open A Pool

Pool season is here and while many open their pools as early as March, Memorial Weekend is symbolically the start of pool season. Opening your pool properly will determine how quickly you and your family will enjoy the pool and will help you avoid potential problems such as chemical imbalance and improper filtration. Below are some key steps to properly opening your pool.

1. Clear or remove your pool cover. If you have an automatic cover you should have been keeping it clear of debris and making sure your pump off all the water prior to trying to operate the automatic cover. If you use a winter cover, remove the cover and store for the pool season. If you do not own an automatic pool cover you should consider a solar cover or other to help keep you pool warm and free from debris.

2. Retrieve all of your stored pool parts out of storage such as: return eyeballs,  o-rings, and  gaskets.

3. Check your equipment:

  • Heater – Just like your home heating system you will want to have your gas pool heater or electric heat pump serviced and ready for the season.
  • Filter – Whatever type of filter you use we recommend examining filter media to make sure it’s clean for maximum filtration. Consider having your filter cleaned professionally when you close or upon opening. Your family will appreciate clean water.
  • Pump – Examine all the wires to ensure no damage, place basket in pump housing and to prevent dry rot and help with a better seal use petroleum jelly or magic lube on gasket before installing (this is also recommended for all o-rings and rubber gaskets).
  • Automation – If your pool is equipped with this option reinstall the ORP and Ph probes. Note:  You should always store inside your house through the winter to prevent freezing.
  • The chlorine generator should be checked on the inside to see if the grids are clean. If they are not clean, use a 50/50 muriatic muriatic muriatic and water mixture to clean.

4. Install the pool return eyeballs, pump, and skimmer baskets.

5. Make sure pool water level is at proper level – middle to upper middle of skimmer.

6. Prime the pump prior to operating. Once everything has been checked and installed, simply fill the pump basket with water.

6. Add chemicals – typically chlorine shock, algaecide, salt, stain and scale preventer.  Your initial chemical composition will vary depending the type of pool that you are running and current levels in the water. Don’t experiment with this.

  • Chlorine pool – with a standard chlorine pool you will need test your water chemistry at least once a week (possibly more with extreme heat conditions) and add the necessary chemicals.
  • Automated pools – you will need to recheck the water within a few days after pool has been circulating to check the reading. Then set all of your levels to your preferred setting and your done for the season.

7. Sweep and brush as needed or use a robotic cleaner (just put in water as needed and it does the work for you). For pools with a lot of large debris, vacuuming on “waste” will  bypass the filter to avoid extra filter cleaning.

8. Monitor the seals, gaskets, o-rings, gauges and fittings closely for the first couple days for leaks.

Opening your pool is a good time to think about converting to a salt water pool. Salt water pools have many advantages including being better for your skin and less irritation on the eyes.

Your pool really is a relatively simple system, however, like anything with pumps and motors, proper maintenance and operation are key. Many chose to have their pools professionally opened and maintained to ensure that everything is functioning properly and to help extend the life of your equipment. We offer many options for opening, closing, and maintaining your pool. Ask about our Mud Club VIP program.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>